Methods For A Smoother Dirt Bike Graphics Application

The thing any rider wants is to end up with an unflattering decal. While graphics are simple to apply to bikes using the adhesive available, it can be tricky to use them properly. Here are a few tips to assist:

Peel the backing paper off Slowly
If you are you are working with larger decals, begin by peeling off the backing paper only from the portion of the decal to be put on first. It's difficult to remove off the backing paper for the entire image all at once. This can lead to errors and, if not done properly, can result in costly mistakes. The decal can wind becoming stuck to objects that it shouldn't or getting tangled together in certain areas, so pull off the backing slowly while it's being applied. When you desire to learn more details about dirtbike graphics, you have to sneak a peek at https://www.instagram.com/decallab/ site.

Reduce Air Bubbles
If applied all at once or without adequate care the image will end into air bubbles. Although this is a common occurrence on plastic fuel tanks, it's easy to get the bubbles out elsewhere on the bike. Just use a soft cloth to smooth out the decal before it goes onto. If that doesn't work or bubbles appear despite the best efforts of the riders to smooth them out, they can take the decal off the plastic a bit and apply it gradually, taking more attention to avoid any imperfections.

Direction is Important
Riders should start peeling off the backing paper before applying graphics to the closest area to them. Air bubbles can be made by applying decals facing opposite directions.

Take a look at the Holes
The parts of the plastic dirt bike graphics have holes that need to line up properly to fit the bike back together. If you've used the part to apply your graphics, be sure to ensure that they are aligned correctly. The graphics for each bike are likely to have holes already drilled into them in order to make it easier to apply the graphics.

Use heat to improve the application of curly sections
Many modern bikes feature curved sections made of plastic. To make the graphic more flexible, heat it with a heat gun instead of heating it directly. This makes it easier to maneuver around curves and not end up with tears or bunching.

Keep Hands Clean
Riders should wash their hands during the entire process of applying decals. Before applying new graphics get rid of any grease, dirt, or adhesives.

Don't Heat Seal until the very end
Once the graphics have been placed correctly, riders need to trim any excess with crafting knives or scissors. Prior to applying heat to the decals, users should trim off any excess material using scissors or craft knives. Anyone who plans to apply multiple graphics should wait until each is properly aligned and installed to seal them in their final position. Riders will not be able to move their positions after the heat is applied. If there is accidents, they could need to remove all decals.

Add Extra Protection
You can use the soft grip tape made of rubber on areas where graphics will be more damaged. The protective layer will have to be replaced each couple of weeks However, it will keep the decals looking brand new and will shield them from UV damage and dust.