There have never been so many options available to alter the appearance of your dirt motorcycle, ATV, UTV or motorcycle and that includes decals and graphics in every color and design you can imagine. It's enjoyable to pick the graphics that you like, but it can be a challenge to put them on when you're not sure what to do.
How to Install Dirtbike Graphics
These are step-by-step directions for applying graphics in a manner that is easy and that will guarantee that your graphics will remain in place and stick.
Dry Installation
1. Clean your hands, your plastics and the work area. Clean the plastic on your machine's front as well as back sides. You can get more information on dirt bike by visiting https://www.flippingheck.com/how-to-choose-a-graphics-company-for-your-dirt-bike/ site.
2. Before applying graphics on your dirt bike Cut the paper backing around the perimeter, making sure it is as close to the image as you can. The paper backing should be removed from the vent's interior and bolt holes. Check that the lines of the vents, holes and curves of the graphic the plastic.
3. Remove half of the backing, taking care not to allow dust or other debris to accumulate onto the adhesive side. Cut the backing along the middle horizontally for side plates and vertically for front plates. Choose a 1/2 inch piece of backing, and cut it off. The remaining backing is placed over the image. Then, line it up using holes or edges.
4. Make sure that the center strip isn't sticking when you align the graphic to the plastic. After the graphic is properly aligned, you can attach the center strip to the plastic.
5. Peel off the backing paper from one side, and then hold the image up and away from the plastic. Slowly apply the image by sliding one finger back and forth across the graphic, pressing out wrinkles and air bubbles. The heat can be applied using the help of a hair dryer or heat gun during the process to remove wrinkles and air bubbles. Be aware that heat can cause decals to stretch out and cause distortion.
6. Peel off the paper backing from the other half Then, apply the design as explained in step 4. For all other graphics, follow the same steps.
Wet Installation
1. Be sure to wash your hands, your plastics, and the area you work in. Clean your plastics on the front and back sides.
2. Cut the backing paper so that it is as close as you can to the graphic prior to applying. The backing paper should be removed from the interior of the vent and bolt holes. Examine the alignment of the holes, vents, curves and edges of the graphic in relation to the plastic.
3. Apply a fine mist of water to your plastic.
4. Remove the backing paper, and make sure the adhesive side is clear. Use a fine mist application fluid to mist the adhesive side.
5. The decal can be applied lightly onto the plastic, while filling up bolt holes and vent holes.
6. After everything is lined up properly, begin from the center, and make use of a squeegee to push the application fluid to the edge of the plastic.
7. While you are continuing the squeegeeing process and continue to squeegee, you can add heat with a heat gun or hair dryer in order to speed up drying process. The use of heat can be utilized to smoothen wrinkles and remove any bubbles. Warning: Excessive heat will cause the decal to overstretch and alter the appearance of the image.
8. Use a clean, dry cloth to remove any excess fluid that is remaining on the edges of the plastic.
9. It is advised that you do not ride your quad or dirt bike for at least 24 hours in order to ensure proper adhesion of the decal.
