How to open a kenmore vacuum cleaner?

​Have you ever wondered how to open a Kenmore vacuum cleaner? It's actually pretty simple - all you need is a screwdriver and a few minutes of time. In this article, we'll show you step-by-step how to do it so that you can get to cleaning your house as soon as possible!

Open the side of the vacuum where the bag is located

If your Kenmore vacuum cleaner has a removable bag, you can open the side of the vacuum where the bag is located. This will give you access to the inside of the Handheld vacuum cleaner so you can clean it out. To remove the bag, simply pull it out of the vacuum and dispose of it.

Find the knob or switch that releases the bag and move it to the open position

If your Kenmore vacuum cleaner has a bag, you'll need to open it before you can start cleaning. Luckily, this is a relatively simple process. Just find the knob or switch that releases the bag and move it to the open position. Then, remove the bag and dispose of any dirt and debris that's inside. After that, you're ready to start vacuuming!

image source: https://www.pinterest.ph

Remove the full bag and dispose of it properly

Assuming you have a canister vacuum, open up the vacuum by removing the cannister from the base. On most Canister vacuum cleaner, there will be a release button or latch on the top of the cannister that will allow you to easily remove it. Once the cannister is off, take out the full bag and dispose of it properly. If your vacuum has a reusable filter, make sure to clean it before putting it back in.

Insert a new bag into the opening, making sure it is seated correctly

If your vacuum cleaner is full, you'll need to empty it before continuing. To do this, remove the hose from the vacuum and place it over a trash can. Then, turn on the vacuum and let it run until it's empty.

Next, you'll need to insert a new bag into the opening. Make sure that the bag is seated correctly before continuing.

Finally, replace the hose and turn on the vacuum. It should be ready to use now.

image source: https://www.pinterest.ph

Close the side of the vacuum, making sure the knob or switch is in the closed position

Locate the screws that hold the bottom plate in place. Remove these screws with a Phillips screwdriver.
Grip the bottom plate and pull it straight out. If the WetDry vacuum cleaner has a power cord, be careful not to damage it as you remove the bottom plate.

Look for the brushroll near the center of the vacuum. The brushroll is a cylinder covered in bristles.
Locate the two clamps on either side of the brushroll. These clamps hold the brushroll in place so it doesn't fall out when you remove the bottom plate.
Use your fingers to squeeze the clamps together and release them from the brushroll.
Pull the brushroll out of its housing. You may need to wiggle it back and forth to get it loose.
Once the brushroll is removed, look for any debris that may be wrapped around the shaft. This debris can prevent the vacuum from working properly.
Use a pair of pliers or your fingers to remove any debris from around the shaft.
Replace the brushroll by inserting it into its housing and squeezing the clamps shut.
Replace the bottom plate by lining up the screws with their holes and screwing them in place with a Phillips screw